Emitter Setup - Barco UDX Series User Manual

GUI – Installation
Source signal
2D Source
Active Stereo source
Passive Stereo source
When a different Display Mode is chosen compared to the source signal (e.g. Active Stereo source
with Mono output), advanced image processing will make sure you a desirable image will be
displayed.
How to select the desired projection method?
1. In the main menu, select Installation → Display Setup.
Image 8-59: Installation menu, Display setup
The Display setup menu is displayed.
2. Select the desired Display Mode:
• AutoStereo (default value)
• Mono
• ActiveStero
Image 8-60
8.8.5 3D emitter Setup
Why change the 3D setup?
While Barco provides a 3D emitter and active shutter glasses as options to this projector, you are free to use a
3D emitter and active shutter glasses of your own choice. Since glasses and emitter can have various
specifications compared to the ones Barco provides, the 3D setup menu allows you to configure the output
image to the specifications of your glasses and emitter. The following can be configured:
• Swap Eye: You can choose to invert the stereo Sync.
• Dark time: You can select how much dark time the projected image will have between frames. You can
choose one of the options between 1000 µs and 2500 µs.
• Sync Delay: You can increase or decrease the sync delay. The scale goes from –10 000 µs to +10 000 µs
with a step of 100 µs.
96 R5906112-06 UDX series
AutoStereo
Output is a 2D image
Output is in Active Stereo Output is a 2D image
Output is in Active Stereo Output is a 2D image
Mono
Output is a 2D image
ActiveStereo
Output is in Active Stereo
Output is in Active Stereo
Output is in Active Stereo