9.3 IR control
Overview
•
Broadcast address
•
Projector address
•
IR sensors
9.3.1 Broadcast address
About broadcast address
Broadcast address is a common address that can be set on the projector. That can be "0" or "1".
Any command coming from a remote control programmed with that common address will be executed.
How to the broadcast address
1.
In the main menu, select System Settings → Communication → IR Control.
Image 9-7: Communication menu, IR control
The IR control menu is displayed.
Image 9-8: IR control menu
2.
To change the broadcast address select the radio button of your choice.
The following choices are possible:
•
Generic IR (address 0)
•
Barco broadcast IR (address 1)
3.
Select APPLY and click OK to apply the changes.
9.3.2 Projector address
About individual projector address
Before a projector, and only this projector, can be controlled via a remote control, an individual address must
be entered in the projector.
This individual projector address can then be used to control the projector via remote control.
GUI – System Settings
R5906112-06
UDX series
103