Appendix; Care; Contact With Liquid; Questions And Answers - Siemens Gigaset 150 Owner's Manual

Appendix

Care

Wipe the base and the handset with a damp cloth (use no solvent) or an antistatic cloth.
Never use a dry cloth as this can cause static discharge!

Contact with liquid

If the handset should come into contact with liquid, on no account switch the device
on. Remove all batteries immediately.
Allow the liquid to drain out of the device, and then pat all parts of the device dry.
Keep the handset with the batteries removed in a warm, dry place for at least 72 hours.
In many cases, you will then be able to use it again.

Questions and Answers

If you have any questions about the use of your phone, you can contact us 24/7 at
www.my-siemens.com/customercare. You will find the most frequently asked ques-
tions and answers below.
What has happened
when ...
... the display is blank?
... the handset fails to respond
to a key press?
... "Base x" flashes in the dis-
play?
... an internet address appears
in the display?
... (when using more than one
handset) the handset that is in
the base does not charge?
... the handset or the base
C 150 does not ring?
... I can hear no ringer tone/
dial tone?
... the other party cannot hear
me?
!
Possible cause
The handset is not switched on.
The batteries are flat.
The keypad lock is activated.
The handset is outside the range
of the base.
The base is not switched on.
The automatic registration of
your handset to the base has
been interrupted.
The base will not charge the
handset if telephoning is simul-
taneously in progress.
The ringer is switched off.
Call Diversion is set to All Calls.
You have changed the telephone
cord on your Gigaset.
You have pressed the INT key.
This mutes the handset.
Appendix
Possible solution
a
Press the 'end call' key
around 2 sec..
Charge or replace the batteries
(page 9).
R
Press the hash key
around 2 sec. (page 10) to
deactivate the lock.
Move the handset nearer to the
base.
Check the power connector at
the base (page 7).
Register your handset manu-
ally (page 53).
Use an additional charger.
Switch on the ringer in the
handset (page 59) or base
C 150 .
Switch off Call Diversion
(page 20).
When purchasing a new cord
ensure that it has the correct
pin assignment (page 7).
Switch on the microphone
again (page 18).
for
for
69