Manual Registration; Gigaset 1000 To 4000 And Other Handsets With Gap Functionality; De-Registering Handsets; Page Handset - Siemens Gigaset 150 Owner's Manual

Registering and de-registering handsets

Manual registration:

Gigaset 1000 to 4000 and other handsets with GAP functionality

This section describes how to connect handsets belonging to the Gigaset families, hand-
sets A 2, C 2, S 1 or handsets of other devices with GAP functionality to your C 100/C
150 .
1. On the handset
Start to register the handset as described in its operating instructions.
2. On the base
The next unassigned internal number (1–6) is automatically assigned to the handset as
it is registered. If all the numbers have been assigned, number 6 is overwritten provided
the handset is in idle status.

De-registering handsets

You can de-register any registered handset from any registered C 1 handset.
[_______]
INT
[_________] [________________]
MENU
[__________] [_____________________________________________________________] De-register Handset
[_______]
OK
[_______]
OK

Page handset

If you have mislaid your handset you can 'page' it with the help of the base. The Regis-
tration/Paging key is on the base to the right of the handset shell (page 40).
Paging ends automatically after 30 seconds.
N
i
The paging call can be heard even when the ringer is switched off.
N
54
Press the Registration/Paging key on the base
(page 40) until you hear a signal tone (C 150 only)
(approx. 3 sec.).. Registration is initiated.
Open list of handsets.
Select the handset you wish to de-register (your own
handset is checked
Select the menu item and confirm.
[_________ ]
OK
Enter the current system PIN (the default setting is
0000) and confirm.
Press the display keyto confirm the prompt.
Press the Registration/Paging key on the base for 1
second. All handsets will ring together ('Paging').
End paging:
Press the Registration/Paging key on the base again
for 1 second or press the top half of the
‰
) and press the display key.
c
key.