Setting Pauses; Switching Temporarily To Tone Dialling (Dtmf) - Siemens Gigaset 150 Owner's Manual

Connecting the base to a PABX

Setting pauses

Changing the pause after line seizure
You can set the length of the pause that is inserted between pressing the top half of the
c
key and the transmission of the telephone number (the default setting is 3 seconds).
[______________]
MENU
[_______]
OK
Change pause after Recall key
You can change the length of the pause if your PABX requires this (refer to the operating
instructions for your PABX; the default setting is 800 ms).
[______________]
MENU
[_______]
OK
Changing the dialling pause
[______________]
MENU
[_______]
OK

Switching temporarily to tone dialling (DTMF)

If your PABX still operates with dial pulsing (DP) but tone dialling (DTMF) is required for
a particular call (e.g. to check your network mailbox), you must switch to tone dialling
during the call.
Precondition: A call is in progress.
[______________]
MENU
[__________] [_____________________________________________________________] Tone dialing
68
Press the display key to open the menu.
Press keys.
Enter a number for the length of the pause
(1 = 1 sec.; 2 = 3 sec.; 3 = 7 sec.; 4 = 2.5 sec.)
and confirm.
Press the display key to open the menu.
Press keys.
Enter a number for the length of the pause
(1 = 800 ms; 2 = 1600 ms; 3 = 3200 ms)
and confirm.
Press the display key to open the menu.
Press keys.
Enter a number for the length of the pause
(1 = 1 sec.; 2 = 2 sec.; 3 = 3 sec.; 4 = 6 sec.)
and confirm.
Press the display key to open the menu.
Select the menu item and confirm. Tone dialling is
now activated for this call.
[_________ ]
OK