Magnetek Elevator HPV1000 AC Technical Manual page 21

A3 Parameter Name
Speed Command 1
Speed Command 2
Speed Command 3
Speed Command 4
Speed Command 5
Speed Command 6
Speed Command 7
Speed Command 8
Speed Command 9
Speed Command 10
Speed Command 11
Speed Command 12
Speed Command 13
Speed Command 14
Speed Command 15
Inspect Oper Spd
Rescue Speed
A4 Parameter Name
Input Voltage
UV Detect Level
Mains Dip Level
PWM Frequency , ,
<2> <3> <4>
OH Pre-Alarm Lvl
Fan Delay Time
<2> Parameter accessible in Open Loop Vector control mode
<3> Parameter accessible in Closed Loop Vector control mode
<4> Parameter accessible in PM Closed Loop Vector control mode
<5> Default is dependent on drive model number
MAGNETEK HPV1000 AC Elevator Drive Technical Manual
Table 3 Multistep Reference A3 Submenu
Description
Sets the Speed command for the drive. Speed command selected
depends on the following table:
Sets speed reference when inspection operation is enabled.
Rescue Operation Speed:
Sets the speed that the elevator will run at when it is in Rescue Operation
Mode.
Note: This setting can be disabled with the setting of Rescue Speed (C1).
Table 4 Power Convert A4 Submenu
Description
This parameter must be set to the power supply voltage.
Sets the DC bus undervoltage trip level.
This parameter sets the level (as a percentage of the Input Voltage -
A4) at which an under voltage alarm will be declared. Units in percent
of nominal bus.
This parameter sets the PWM or 'carrier' frequency of the drive.
Set an OVRLD shutdown alarm that will occur if the drive heatsink
temperature exceeds this setting.
Sets a delay time to shut off the cooling fan after the run command is
removed.
Note: This operating mode can be disabled.
5 Programming
Units Default
m/s 000.00
m/s 000.00
m/s 000.00
m/s 000.00
m/s 000.00
m/s 000.00
m/s 000.00
m/s 000.00
m/s 000.00
m/s 000.00
m/s 000.00
m/s 000.00
m/s 000.00
m/s 000.00
m/s 000.00
m/s 0.00
m/s 0.00
Units Default
VAC 400
<5>
VDC 380
<5>
% 80
kHz ,, 08.0
<2> <4> <5>
C 110
<5>
Sec 20
19