Backup And Restore Configuration; System Logging - Fujitsu PSWITCH 2048T User Manual

User's Guide

2.4.6. Backup and Restore Configuration

The backup and restoration of the switch configuration is done with the copy
command. This switch firmware has a capability to maintain three configurations
in the permanent storage. The names of the three configurations are the
'first-config', 'second-config', and 'third-config'. The configuration copied to the
'startup-config' becomes effective after reboot.
If you back up the current configuration to a server, use the copy command as in
the following example. The current -- startup-config, is copied to the file named
'startup-config.backup' in the server with IP address 192.168.1.10.
#copy nvram:startup-config tftp://192.168.1.10/startup-config.bkup
In the same way, you back up the second configuration with the following
command.
#copy nvram:second-config tftp://192.168.1.10/second-config.bkup
The restoration of the configuration file is a reverse operation of the backup. If you
restore the 'startup-config.bkup' file above into the switch, use the following
command, and reload the configuration or reboot the switch.
#copy tftp://192.168.1.10/startup-config.bkup nvram:startup-config
#reload configuration
The configuration file is checked at the download to the switch, and if it contains
any format or command error, it would not be saved in the configuration.

2.5. System Logging

The following command displays the current configuration of the logging.
#show logging
Logging Client Local Port
Logging Client Source Interface
CLI Command Logging
Console Logging
Console Logging Severity Filter
Buffered Logging
Buffered Logging Severity Filter
Persistent Logging
Persistent Logging Severity Filter : info
Syslog Logging
Log Messages Received
Log Messages Dropped
Log Messages Relayed
December/2018
: 514
: (not configured)
: enabled
: enabled
: error
: enabled
: info
: enabled
: enabled
: 195
: 0
: 0
FUJITSU PSWITCH
27