Getting Started With Configuration; Rack Mounting; Installation Of L-Shaped Brackets And Rack Rails - Fujitsu PSWITCH 2048T User Manual

FUJITSU PSWITCH

2 Getting Started with Configuration

2.1. Mounting
Install this unit in a standard 19-inch rack. Install from the back of the rack. Follow
the procedure below to install the equipment.
I When carrying out maintenance support by our technical experts, prepare
with reference to the contents of Chapter 4 "Maintenance" - "4.1.
Preparation".

2.1.1. Rack Mounting

Please pay attention to the following points before installation work.
 Do not place another device on the rack mounted device.
 Be careful not to exceed the limit of the power supply of rackmounted
equipment.
 Be careful to ensure that the rack mounted equipment is properly insulated.

2.1.1.1. Installation of L-shaped brackets and rack rails

Attach the L-shaped brackets to the front of the server as shown in the figure below.
Please attach so that the L shape brackets with model name and number label
attached is on the left side of the front side of the equipment. For each L-shaped
bracket, attach it by using 2 screws for PSWITCH 2048T/P and 3 screws for PSWITCH
4032P. Release and detach the inner member from the slide. Attach the inner
member to the unit.
14
User's Guide
December/2018