Introduction - Danfoss FCM 300 Operating Instructions Manual

Introduction

Copyrights, Limitation of Liability and Revision Rights.
This publication contains information proprietary to
Danfoss A/S. By accepting and using this manual the
user agrees that the information contained herein will
be used solely for operating equipment of Danfoss A/S
or equipment from other vendors provided that such
equipment is intended for communication with Danfoss
equipment over a PROFIBUS serial communication
link. This publication is protected under the Copyright
laws of Denmark and most other countries.
Danfoss A/S does not warrant that a software program
produced according to the guidelines provided in
this manual will function properly in every physical,
hardware or software environment.
Although Danfoss A/S has tested and reviewed the
documentation within this manual, Danfoss A/S makes
no warranty or representation, either express or implied,
with respect to this documentation, including its quality,
performance, or fitness for a particular purpose.
In no event shall Danfoss A/S be liable for direct,
indirect, special, incidental, or consequential damages
arising out of the use, or the inability to use information
contained in this manual, even if advised of the
possibility of such damages. In particular, Danfoss
A/S is not responsible for any costs including but not
limited to those incurred as a result of lost profits
or revenue, loss or damage of equipment, loss
of computer programs, loss of data, the costs to
substitute these, or any claims by third parties.
Danfoss A/S reserves the right to revise this publication
at any time and to make changes in its contents
without prior notice or any obligation to notify previous
users of such revisions or changes.
When reading through this manual, you will come
across various symbols that require special attention.
The symbols used are the following:
Indicates a general warning.
NB!:
Indicates something to be noted by the reader.
2
FCM 300 / FCD 300 / VLT
®
2800 / DP V1 PROFIBUS
Indicates a high-voltage warning.
PROFIBUS is a registered trademark.
About this manual
This manual describes the Profibus communication
in the following products:
- FCM 300
- FCD 300
- VLT 2800
The following table shows from which software versions
Profibus DPV1 is supported. The software version can
be read-out in parameter 624 Software versions.
Unit Software version
FCM 300 Not supported
FCD 300 Ver. 1.3x/2.x
VLT 2800 Ver. 2.6x/2.x
This manual gives detailed information of the DP V0
features supported, sufficient for most programming
and maintenance activities. The DP V1 however
is briefly described. For programming purposes
the Profibus DP V1 Design Guide order number
MG.90.EX.YY (X is the version number, and YY the
language code) might be necessary.
It is suggested that readers who are not
completely familiar with PROFIBUS DP or the
profile for frequency converters review the relevant
literature on these subjects.
Even if you are an experienced PROFIBUS programmer,
we suggest that you read this manual in its entirety
before you start programming, since important
information can be found in all chapters.
Assumptions
This manual assumes that you are using a DANFOSS
FCM 300, FCD 300 or VLT 2800 with PROFIBUS. It is
also assumed that you, as a master, are using a PLC or
PC that is equipped with a serial communication card
supporting all the PROFIBUS communication services
required by your application. Further, it is assumed
that all requirements stipulated in the PROFIBUS
standard as well as those set up in the PROFIBUS
frequency converters Profile and its company-specific
implementation PROFIDRIVE, as well as those
pertaining to the frequency converter are strictly
observed as well as all limitations therein fully respected.
MG.90.A5.02 - VLT is a registered Danfoss trademark