Parameters - Danfoss FCM 300 Operating Instructions Manual

®
FCM 300 / FCD 300 / VLT 2800 / DP V1 PROFIBUS
FCM 300, FCD 300, VLT 2800 parameters
Only the PROFIBUS specific parameters (800 - 805
and 904 . . ) are described in this manual. All other
parameters and their functions are unaffected by
the PROFIBUS option. We refer to the parameter
description in the design guide on the FCM 300
Series (MG.03.Bx.02), the design guide on the FCD
300 (MG.04.Ax.02) and the design guide on the VLT
2800 Series (MG.28.EX.02). Please note, that some
parameters might not be active in all products.
Special attention must be given to the following
parameters that are not described in this manual:
- 502- 508: Selection of how to gate PROFIBUS
control commands with control commands on the
digital inputs of the FCM 300/FCD 300/VLT2800.
- 512: Control word profile, selects a control
word according to profidrive or a Danfoss
specified control word.
- 515 - 543: Data readout parameters that can be
used to read various actual data from the frequency
converter, as for example actual status on the analog
and digital inputs of the FCM 300/FCD 300/VLT 2800
thus using these as inputs to the master.
MG.90.A5.02 - VLT is a registered Danfoss trademark
31