List Of Memory Switch Settings - Brother BAS-326G Service Manual

2-4. List of memory switch settings

Setting
No.
range
Work clamp lift timing after sewing is completed
001 OFF
ON
Separate-type work clamp drop operation (pneumatic specifications)
0
002
1
2
Work clamp drop operation (solenoid specifications)
0
003
1
2
Sewing start speed
OFF
100
ON
Single-stitch test feed
OFF
200
ON
Production counter display
300 OFF
ON
User programs
400 OFF
ON
Cycle programs
401 OFF
ON
Maximum reduction ratio (mm display) (*1)
402 OFF
ON
Split mode selection
0
403
1
2
*1 The mm display may differ slightly from the actual sewing size.
Lifts at the final stitch position.
Lifts after moving to the home position.
Left and right work clamp drop at the same time.
Work clamp drops in the order left → right.
Work clamp drops in the order right → left.
Analog dropping: Work clamp drops in direct proportion to the pedal depression
amount, and sewing starts when the pedal is fully depressed
1st step drop: Work clamp drops when pedal is depressed to the 1st step, and
sewing starts when pedal is depressed to the 2nd step
2nd step drop: Work clamp drops to intermediate height when the pedal is
depressed to the 1st step, and work clamp drops and sewing starts when the
pedal is depressed to the 2nd step.
The sewing speed for the first 1 − 5 stitches is set by memory switch numbers 151
− 155.
1st stitch at 400 rpm, 2nd stitch at 400 rpm, 3rd stitch at 600 rpm, 4th stitch at 900
rpm, 5th stitch at 2,000 rpm
Test feed starts when the foot switch (start switch) is depressed, and it continues
automatically until the final stitch.
Test feed is carried out one stitch at a time when the foot switch (start switch) is
depressed (feed becomes continuous if the foot switch [start switch] is
continuously depressed).
In addition, when the TEST indicator is illuminated, test feeding will move forward
one stitch at a time when the machine pulley is turned by hand.
Lower thread counter display
Production counter display
Disabled
User program mode is enabled.
Disabled
When sewing user programs, the set programs are sewn in numeric order.
Displayed as %.
Displayed as mm.
Continuous split (split menu is disabled before split detection)
Continuous split (split menu is always enabled)
Independent split
Setting items
BAS-311G, BAS-326G
2. FUNCTION SETTINGS
Initial value
ON
0
2
OFF
OFF
OFF
OFF
OFF
OFF
0
5