List Of Memory Switch Settings - Brother BAS H series Instruction Manual

2-2. List of memory switch settings

Setting
No.
range
Work clamp lift timing after sewing is completed
0
001
1
2
Work clamps
specifications/BAS341H/BAS342H)
0
1
002 2
Work clamp lowering operation (BAS341H/BAS342H only)
0
1
2
Work clamp lowering operation (Motor-driven work clamp specifications only)
0
003
1
2
Slow start method
OFF
100
ON
Single-stitch test feed
OFF
200
ON
Sewing condition detail settings
400
OFF
ON
Split mode selection
403 0
1
(*1) The position of the work clamp stopper must be set.
Work clamp is not raised automatically.
Work clamp is raised at the final stitch position.
Work clamp is raised after moving to the home position.
lowering operation
Left and right work clamps are lowered at the same time.
Work clamps are lowered in order left > right.
Work clamps are lowered in the order right > left.
Work clamp dropping in one step
Work clamp dropping in two steps (*1)
Do not use this setting.
Analog lowering: Work clamp is lowered in direct proportion to the pedal
depression amount, and sewing starts when the pedal is fully depressed.
* This operation is only possible for foot switch specifications; for two-pedal foot
switch specifications, operation is the same as for a 2-step work clamp.
1-step work clamp: Work clamp is lowered when pedal is depressed to the 1st step,
and sewing starts when pedal is depressed to the 2nd step.
2-step work clamp: Work clamp is lowered to intermediate height when pedal is
depressed to the 1st step, and work clamp is fully lowered and sewing starts when
the pedal is depressed to the 2nd step.
The sewing speed for the first 5 stitches will be in accordance with the setting for
memory switch Nos. 151 to 155. (Ask the place of purchase for details on memory
switch Nos. 151 to 155.)
The sewing speed for the first 5 stitches can be selected from the nine slow start
patterns "Lo1" to "Lo9". (Refer to Slow start pattern in "1-2. Parameter setting
method".)
Test feed starts when the foot switch (start switch) is depressed, and it continues
automatically until the final stitch.
Test feed starts when the foot switch (start switch) is depressed, and it moves
forward by one stitch each time the switch is depressed.
In addition, after test feed starts, test feed will move forward one stitch at a time
when the machine pulley is turned by hand.
Parameters which are common to all programs are used.
Parameters can be set separately for each program.
Continuous split mode
Single split mode
2. USING THE LCD PANEL (ADVANCED OPERATIONS)
Setting items
(Models other than
BAS H series
pneumatic work clamp
Initial value
2
0
0
2
OFF
Lo4
OFF
OFF
0
16