Lower Shaft Mechanism - Brother BAS-326G Service Manual

5. DISASSEMBLY

5-7. Lower shaft mechanism

5095Q
Remove the rock gear and the
crank rod together as a single unit.
5098Q
48
If the adjusting stud will not pull out,
insert a M3 screw into the tap hole and
then pull out the adjusting stud.
BAS-311G, BAS-326G
1. Bolt (Loosen)
2. Driver
3. Retaining ring E
4. Set screw (Loosen)
5. Adjusting stud (Pull out)
6. Lower shaft assy
[Pull out from the rear of the machine]
7. Adjusting stud (Pull out)
8. Set screw (Loosen)
9. Screw (Loosen)
10. Shuttle race base assy
5097Q
11. Set screws [2 pcs] (Loosen)
12. Set screw (Loosen)
13. Set screw collar, R
14. Set screws [2 pcs] (Loosen)
15. Set screw collar, B
16. Rock gear shaft
[Pull out from the rear of the machine]
17. Rock gear
18. Crank rod [Lower part]
5096Q