List Of Memory Switch Settings - Brother S-7300A-333P Instruction Manual

6-9. List of memory switch settings

Presser foot lifter and treadle settings (001 to 099)
No. Setting range
001 ON/OFF
002 ON/OFF
003 ON/OFF
004 ON/OFF
010 ON/OFF
011 0 - 1
012 0 - 500
(ms)
013 ON/OFF
014 ON/OFF
015 ON/OFF
(*1) Other than Europe and America: ON
Europe and America: OFF
Initial
Setting
value
units
(*1)
When treadle is returned to neutral after thread trimming, presser foot is
－
raised up
ON: Presser foot is raised
OFF: Presser foot is not raised
(*) The presser foot lifts when MSW-851 is set to "OFF".
OFF
After treadle stops at neutral, presser foot is raised up
－
ON: Presser foot lifts
OFF: Presser foot is not lifted
ON After treadle stops at neutral, presser foot is possible to raised up when
－
treadle depressed one step backward.
ON : Enabled
OFF: Disabled
ON When treadle depressed backward, thread trimming and end backtack
－
sewing is possible.
ON: Thread trimming and end backtack sewing operations are enabled
OFF: Thread trimming and end backtack sewing operations are disabled
OFF After standing up pedal is used, treadle operation is possible.
－
(Alternating operation is possible)
(*) For simultaneous operation which includes operation of the presser foot
lifter pedal, operation of the standing operation pedal takes priority.
ON: Treadle operation is still enabled after standing operation pedal has
OFF: Treadle operation is disabled after standing operation pedal has been
0 Operation when standing up variable speed pedal is ON
1
0: Sewing speed corresponds to treadle depression amount
1: Sewing speed corresponds to sewing speed set for main sewing
(constant speed)
80
10 Delay time from standing pedal turning on until motor starts operating
(ms)
(ms)
ON When AUTO function is set ON, pauses when presser foot pedal is ON.
－
ON: Sewing is interrupted when presser foot lifter pedal turns on (pause
OFF: No operation
ON When AUTO function is set ON, it can be changed ON/OFF of motor
－
operation by slightly pressing high speed pedal.
ON: Motor operation switches on/off each time the high-speed pedal is
OFF: Disabled (sewing machine motor does not stop)
ON After thread trimming, possible to lift up and down by thread trimming
－
pedal
ON: Presser foot can be raised and lowered
(*) If MSW-051 is set to "ON", thread trimming pedal operation is disabled
OFF: No operation (only possible using presser foot lifter pedal)
6. USING THE OPERATION PANEL (ADVANCED OPERATIONS)
(Refer to the Service Manual for details on MSW-851.)
(However, if thread trimming operation is locked, needle up operations
will be carried out without thread trimming.)
(presser foot lifts when the treadle is depressed backward)
been used (alternating operation is possible)
used
operation)
depressed slightly to ON and back to OFF
after the presser foot lifter pedal has been operated during standing
operation.
(Refer to the Service Manual for details on MSW-051.)
S-7300A
Setting details
50