Static Alignment Optimization (With 743L100 L.a.s.a.r. Posture) - Otto Bock 3C96-1 Instructions For Use Manual

C-leg compact prosthetic system
Hide thumbs Also See for 3C96-1:
Table of Contents

Advertisement

Available languages

Available languages

The battery is empty upon delivery. The battery of the C-Leg compact must therefore be charged prior to the first fitting
of the patient.
1 Bend the C-Leg compact until it hits the stop.
2 Open the plastic cover of the protective elastomer cap.
3 Connect the 4E50-* Charger and verify the charging process (see following figures).
Both LEDs are off.
No power supply
(or defective charger)
4 After charging, remove the charging plug (C-Leg compact performs self-test) and close the plastic cover. Only
afterwards, bring the prosthesis into extension.
INFORMATION
• The capacity of a fully charged battery is sufficient for one full day. We recommend charging the battery over
night when using the prosthesis on a daily basis.
• Charging is only possible at temperatures above 0 °C.

3.5 Static Alignment Optimization (with 743L100 L.A.S.A.R. Posture)

C-Leg compact Prosthetic System
Both LEDs are lit.
Battery is being charged.
Battery capacity is lower
than 50%.
Load line
Load line 30 mm in
front of alignment
reference point
Yellow LED flashes;
green LED is lit.
Battery is being charged.
Battery capacity is above
50%.
Alignment reference point
Yellow LED is off;
green LED is lit.
Battery is fully charged
(or connection with C-Leg
compact is interrupted).
Ottobock | 35

Advertisement

Table of Contents
loading

This manual is also suitable for:

3c86-1

Table of Contents