Advertisement

OWNER ' S OPERATION AND INSTALLATION MANUAL
BN28TYLA-W
BL28TYLA-W
BN28TYLA-C
BL28TYLA-C
BN28TYLA-O
BL28TYLA-O

Table of Contents

Safety Information Warnings.................................2
Air for Combustion and Ventilation......................4
Installation................................................................6
Operating heater.....................................................11
Trouble Shooting...................................................13
Specifications.........................................................15
Replacement .........................................................16
Parts List..................................................................20
Logs installation instruction.................................21
Mantel installation instructions............................22
Assembling anchor...............................................27
WARNING: If the information in this
manual is not followed exactly, a fire or
e x p l o s i o n m a y r e s u l t causing property
damage, personal injury, or loss of life.
WARNING: This is an unvented gas-fired
heater. It uses air (oxygen)f r o m t h e r o o m
i n
w h i c h
i t
i s installed. Provisions for
adequate combustion and ventilation air must
b e p r o v i d e d . R e f e r t o A i r F o r Combus-
tion and Ventilation section on page 4 of this
manual.
CINTINENTAL APPLIANCE INC
5 Musick
Irvine
CA 92618
TOLL FREE NUMBER: 1-877-886-5989
Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any
other appliance.
WHAT TO DO IF YOU SMELL GAS
Installation and service must be performed by a
qualified installer, service agency, or the gas
supplier.
a l t e r a t i o n ,
can cause injury or property damage. Refer to this
m a n u a l
operational procedures. For assistance or addi-
t i o n a l
installer, service agency, or gas supplier.
This appliance may be installed in an aftermarket*,
p e r m a n e n t l y
(mobile) home, where not prohibited by local
codes.
This appliance is only for use with the type of gas
i n d i c a t e d
appliance is not convertible for use with other
gases.
WATER VAPOR: A BY-PRODUCT OF UNVENTED ROOM
HEATERS
Water vapor is a by-product of gas combustion.An unvented
room heater produces approximately one(1) ounce (30ml)
of water for every 1,000 BTU's(.3KW's) of gas input per
hour. Refer to page 3.
Consumer: Please retain these instructions for future
use.
Installer: Please leave these instructions with the
4600 Highlands parkway S.E
*Aftermarket: Completion of sale, not for purpose of resale,
SUITE # D/E
from the manufacturer.
Smyrna, GA 30080
1
Do not try to light any appliance.
Do not touch any electrical switch; do not
use any phone in your building.
Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
If you cannot reach your gas supplier, call
the fire department.
WARNING: Improper
s e r v i c e
f o r
c o r r e c t
i n f o r m a t i o n
l o c a t e d ,
o n
t h e
consumer.
V E N T - F R E E G A S
FIREPLACE SYSTEM
installation, adjustment,
o r
m a i n t e n a n c e
i n s t a l l a t i o n
c o n s u l t
a
q u a l i f i e d
m a n u f a c t u r e d
r a t i n g
p l a t e . T h i s
a n d

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the BN28TYLA-W and is the answer not in the manual?

Questions and answers

Summary of Contents for Procom BN28TYLA-W

  • Page 1: Table Of Contents

    V E N T - F R E E G A S FIREPLACE SYSTEM OWNER ’ S OPERATION AND INSTALLATION MANUAL BN28TYLA-W Do not store or use gasoline or other flammable BL28TYLA-W vapors and liquids in the vicinity of this or any other appliance.
  • Page 2: Safety Information Warnings

    SAFETY INFORMATION WARNINGS 4. This heater shall not be installed I M P O R TA N T: R e a d t h i s WARNING: Do not use a blower in a bedroom or bathroom. owner’s manual carefully and insert, heat exchanger insert, or other 5.
  • Page 3 *Available from: American National Standards PRODUCT FEATURES SAFETY INFORMATION SAFETY PILOT lnstitute, lnc. Continued 1430 Broadway 15. Turn off and unplug heater and let New York, NY 10018 This heater has a pilot with an cool before servicing. Only a National Fire Protection Oxygen Depletion Sensing (ODS) qualified service person should...
  • Page 4: Air For Combustion And Ventilation

    AIR FOR COMBUSTION AND VENTILATION Confined and Unconfined Space Unusually Tight Construction WARNING: This heater shall not be installed in a confined space or The National Fuel Gas Code, ANS The air that leaks around doors and unusually tight construction unless Z223.1 defines a confined space as a windows may provide enough fresh provisions are provided for adequate...
  • Page 5 3. Add the Btu/Hr of all fuel burning appliances in the space. Vent-free heater Btu/Hr Example: Gas water heater* Btu/Hr Gas water heater 30,000 Btu/Hr Gas furnace Btu/Hr Vent-free heater 26,000 Btu/Hr Vented gas heater Btu/Hr Total 56,000 Btu/Hr Gas heater logs Btu/Hr Other gas appliances* + Btu/Hr...
  • Page 6: Installation

    INSTALLATION NOTICE: This heater is in- tended for use as supplemental heat. Use this heater along with your primary heating system. Do not install this heater as your primary heat source. If you have a central heating system, system's circulating blower while using heater.
  • Page 7 INSTALLATION Continued CONNECTING TO GAS The installer must supply an external IMPORTANT : Install equipment SUPPLY regulator. The external regulator will shutoff valve in an accessible location. reduce incoming gas pressure. You The equipment shutoff valve is for WARNING: A qualified service must reduce incoming gas pressure turning on or shutting off the gas to person must connect heater to gas...
  • Page 8 INSTALLATION Continued CHECKING GAS CONNECTIONS WARNING: Test all gas piping CAUTION: Make sure external WARNING: Never use an open and connections for leaks after regulator has been installed be- flame to check for a leak. Apply a installing or servicing. Correct all tween gas supply and heater.
  • Page 9 Installing Blower Accessory ACCESSORY PF06-YJLF-F screwdriver (See Picture 5). wheel and there are no foreign ob- jects in blower wheel. Attach the two brackets to blower Tools required: Phillips screwdriver 13. Do not let the wires touch the re- housing using four white screws NOTICE: Shut off gas heater during flector of the firebox.
  • Page 10 Installing Blower Accessory Blower Accessory Model PF06-YJLF-F...
  • Page 11: Operating Heater

    INSTALLATION Continued INSTALLING LOGS WHAT TO DO IF YOU SMELL GAS With control knob pressed in, SEE WARNING on Page 2 for proper press and release ignitor button. WARNING: Failure to position instructions. This will light pilot. The pilot is the parts in accordance with these C.
  • Page 12: Cleaning&Maintenance

    INSTALLATION Continued INSPECTING BURNERS CLEANING AND MAINTENANCE C h e c k p i l o t f l a m e p a t t e r n a n d WARNING: Turn off heater and burner flame patterns often. let cool before cleaning.
  • Page 13: Troubleshooting

    CLEANING AND MAINTENANCE Continued Clean the pilot assembly also. A CABINET MAIN BURNER y e l l o w t i p o n t h e p i l o t f l a m e Air Passageways Periodically inspect all burner flame indicates dust and dirt in the pilot vacuum cleaner...
  • Page 14 TROUBLESHOOTING Continued OBSERVED PROBLEM POSSIBLE CAUSE REMEDY 1. Control knob not fully pressed in. 1. Press in control knob fully. ODS/pilot lights but flame goes out when control knob is released. 2. Control knob not pressed in long 2. After ODS/pilot lights, keep enough.
  • Page 15: Specifications

    SPECIFICATIONS BN28TYLA-W BL28TYLA-W BN28TYLA-C BL28TYLA-C BN28TYLA-O BL28TYLA-O Btu(Variable) Gas Type LP Gas Natural Gas Ignition Piezo Piezo Manifold Pressure 8"W.C. 3"W.C. Inlet Gas Pressure (In. of water)* Maximum 14" 10.5" Minimum 11" 5" Dimensions, Inches (H × W × D) Heater 36 1/4”...
  • Page 16: Replacement

    REPLACEMENT PARTS REPLACEMENT PARTS ACCESSORIES NOTE: Use only original replacement Purchase these heater accessories parts. This will protect your warranty from your local dealer. If they can not coverage for parts replaced under supply these accessories, call PRO- warranty. COM’s toll free number at (1-877- 886-5989)for referral information.
  • Page 17 ILLUSTRATED PARTS BREAKDOWN BN28TYLA-W BL28TYLA-W BN28TYLA-C BL28TYLA-C BN28TYLA-O BL28TYLA-O...
  • Page 18 This list contains replaceable parts used in your heater. When ordering BN28TYLA-W parts, follow the instructions listed under Replacement Parts on page 16 of this manual. BL28TYLA-W BN28TYLA-C BN28TYLA-W BN28TYLA-C BN28TYLA-O refer to NG column BL28TYLA-C BL28TYLA-W BL28TYLA-C BL28TYLA-O refer to LP column BN28TYLA-O BL28TYLA-O t e l t a l "...
  • Page 19 ILLUSTRATED PARTS BREAKDOWN BN28TYLA-W BL28TYLA-W BN28TYLA-C BL28TYLA-C BN28TYLA-O BL28TYLA-O...
  • Page 20: Parts List

    This list contains replaceable parts used in your heater. When ordering BN28TYLA-W parts, follow the instructions listed under Replacement Parts on page 16 of this manual. BL28TYLA-W BN28TYLA-W BL28TYLA-W refer to WHITE column BN28TYLA-C BN28TYLA-C BL28TYLA-C refer to CHERRY column BL28TYLA-C BN28TYLA-O BL28TYLA-O refer to OAK column...
  • Page 21: Logs Installation Instruction

    LOGS INSTALLATION INSTRUCTIONS STEP 1: Install the log 1on the angle iron. 1. All logs. See FIG(1). See FIG(2). FIG(1) FIG(2) STEP 3:Install the log 3 on the front angle. STEP 2:Install the log 2 on the right rear See FIG(4). iron.
  • Page 22: Mantel Installation Instructions

    Mantel Installation Instructions...
  • Page 23 Assemble the Base 1. Set top base panel on the ground, with the surface marked 1 upward. Set connectors in four screwed holes in the top base panel ( Note: Be sure to fasten the connectors tightly)- See FIG (a). Connector FIG (a) 2.
  • Page 24 4. Set top base panel on the ground, with the surface marked 1 upward. Set connectors in seven screwed holes in the top base panel (Note: Be sure to fasten the connectors tightly), See FIG (f). Connector Base Connector FIG (f) 5.
  • Page 25 Installation Instructions of Mantel and Fireplace Note: The fireplace is quite big and heavy. For your safety, at least two people are needed to install the fireplace to avert tilting. Install fireplace in the desired position. Install two brackets at the fixed place with six 5×35 self-tapping screws and anchors as shown in FIG (1), assembling the anchors see page 27.Tear the dust-proof plastic film off regulator.
  • Page 26 FIG (2) Install base Push base to mantel and ensure the rear part of the base fits with the col- umn face closely, see FIG (3). FIG (3)
  • Page 27: Assembling Anchor

    ASSEMBLING ANCHOR 1. To ensure the assembling position of anchor per FIG (1), use the hole of anchor to mark the position of screw on the wall and then move the anchor away. 2. Attaching to Wall Stud Method For attaching bracket to wall studs a.

This manual is also suitable for:

Bl28tyla-wBn28tyla-cBl28tyla-cBl28tyla-oBn28tyla-o

Table of Contents