Assembling Anchor - Procom BN28TYLA-W Owner's Operation And Installation Manual

1. To ensure the assembling position of anchor per FIG (1), use the hole of anchor to mark the
position of screw on the wall and then move the anchor away.
2. Attaching to Wall Stud Method
For attaching bracket to wall studs
a. Drill holes at marked locations using 9/64" drill bit.
b. Place bracket onto wall. Line up last hole on each end of bracket with holes drilled in
wall.
c. Insert mounting screws through bracket and into wall studs.
d. Tighten screws until bracket is firmly fastened to wall studs.
Attaching to Wall Anchor Method
For attaching bracket to hollow walls (wall areas between studs) or solid walls (concrete
or masonry)
a. Drill holes at marked locations using 5/16" drill bit. For solid walls (concrete or
masonry), drill at least 1" deep.
b. Fold wall anchor as shown in Figure 4 below.
c. Insert wall anchor (wings first) into hole. Tap anchor directly into the wall.
d. For thin walls (1/2" or less), insert red key into wall anchor. Push red key to pop open
anchor wings (see Figure 5).
Figure 4 - Folding Anchor
e. Place bracket onto wall. Line up last hole on each end of bracket with wall
anchors.
f. Insert mounting screws through bracket and into wall anchors.
g. Tighten screws until bracket is firmly fastened to wall.
IMPORTANT: Do not hammer key! For thick walls (over 1/2" thick) or solid
wall,do not pop open.

ASSEMBLING ANCHOR

2 7
Figure 5 - Popping Open An-
chor Wing For Thin Walls