Adjustment; Adjustment At Time Of Parts Replacement; Registering The Number Of Punch Holes - Canon Finisher-Q1 Service Manual

4.3 Adjustment

4.3.1 Adjustment at Time of Parts
Replacement
4.3.1.1 Registering the Number
of Punch Holes
Setting the Type of Punch Unit Hole (when punch unit
connected)
1）Set the DIP switch (SW1) as follows:
1
2
3
4
*1: 1 cycle of flashing consists of ON for 300 msec
and then OFF for 200 msec.
3) When the desired type is selected, hold down the
push switch so that the LED will remain on, indicating
that the selected type has been registered in EEPROM.
4) Put the push switch (SW2) back to its original
setting, and turn off and then on the power.
0008-1801
LED
flashes once and goes off*1
flashes 2 times and goes off*1
flashes 3 times and goes off*1
flashes 4 times and goes off*1
ON
1 2 3 4
F-4-1
2）Then, select the type of punch unit by the push
switch (SW2). Each press on the push switch will
cause the indication to change repeatedly from 1 to 4
shown in the table.
Unit type
4-hole unit (French)
2/3-hole unit
2-hole unit
4-hole unit (Sweden)
Chapter 4
T-4-4
4-3