KROHNE OPTIWAVE 7300 C Handbook page 11

Handbook OPTIWAVE 7300 C
Other specifications for fittings
For the gauge to make accurate measurements and have a good signal reflected back from the product
surface:
• ensure a good fit with the gauge process connection
• the radar must point directly down onto the product. Angle offset tolerance ±2° from vertical
• the tank roof must support the weight of the meter
Process connection and entry pipes
Do not put the process connection close to the entry pipe!
Pouring the product directly onto the antenna or directly below will cause measurement errors!
11 OPTIWAVE 7300 C