Connecting Softened Tap Water To Both Connections - Henny Penny FlexFusion Installation Manual

6.5.2 Connecting softened tap water to both connections

INFORMATION
Requirement Water pressure complies with the specified range (see "Equipment
3. Insert dirt filters into the water connections on the unit.
4. Connect the tap water connection line to the unit.
5. Connect the soft water connection line to the unit.
6. Open the tap water valves and check the threaded connectors for
leaks.
7. Fill out the Commissioning report.
Image: Water connection
a Connection line
b Softened tap water
c Tap water
If only softened tap water is available at the installation site, use a T-
piece to connect both water connections on the unit to each other.
The units must be connected individually.
Do not route the connection line together.
and connection data")
Backflow preventer installed
The connection line is pressure-tight and suitable for tap water
1. Connect the connection line to the tap water valve for soft water
using a seal.
2. Flush the connection line thoroughly.
3. Insert dirt filters into the water connections on the unit.
4. Connect the T-piece to the unit.
5. Connect the connection line for soft water to the T-piece using a
seal.
6. Open the tap water valve and check the threaded connectors for
leaks.
Installation instructions
Connecting the unit
e
f
d
d Backflow preventer
e Softened tap water connection
f Tap water connection
a
b
c
31