Table of Contents
Advertisement
Requirement Unit unpacked
5.3 Placing the unit on the equipment legs
Requirement The floor must support the weight of the unit
5.4 Aligning the unit
Protective film removed
Unit cleaned
The rear support is present
1. Slide the forks of the pallet truck under the unit and to the right of
the waste trap.
2. Place the rear support of the unit on the forks of the pallet truck.
3. Gently raise the forks and make sure, that the rear support does
not shift and that it is securely in contact with the unit.
4. Lift the unit carefully off the pallet.
1. Use appropriate lifting gear to lift the unit.
2. Set up the unit in accordance with the planning drawing.
3. Align the unit lengthwise and crosswise (see "Aligning the unit").
Image: Placing the unit on the equipment legs
1. Place a spirit level on the unit.
2. Align the unit horizontally by screwing the equipment legs in or
out.
3. Fill out the Commissioning report.
Installation instructions
Setting up the unit
19
Advertisement
Table of Contents
