Henny Penny FlexFusion Installation Manual page 14

Description of the unit
Basic setting
Kitchen management
system
80 % power
Power optimisation
system
Settings parameters
Basic control setting (Advanced)
Basic setting
Preheating
temperature
Ready2Cook
Condensation-hood
after-running time
Preselected steaming
temperature
Preset
combisteaming
temperature
Preset hot air
temperature
Preset regeneration
temperature
Maximum waiting
time after
Ready2Cook for T <
250 °C (482 °F)
Maximum waiting
time after
Ready2Cook for T >
250 °C (482 °F)
Time format
14
Parameter Standard
s value
Disabled
Ethernet
3 100
42 Off
Parameter Standard
s value
4 15
5 60
9 100
10 150
11 180
12 130
37 120
38 30
675 0
Installation instructions
Adjustment Explanation
range
Active Port and unit address can be set.
Disabled
Ethernet Type of signal transmission
Serial
80 % Power can be limited to 80 % (for special
applications).
100 %
On If a power optimisation system is
connected, "On" must be selected for the
Off
unit to heat.
1. Set parameters via the roller.
2. Tap the "Read" button to display the
set value.
3. Specify another value via the button
panel.
4. Press the "Write" button to save the
new value.
Range of Explanation
adjustment
0 — 30% When loaded a full charge of large masses
(roasts, loaf of bread), increase the
preheat temperature so that the oven
temperature does not drop too suddenly.
0 – 600 s Time extension for the condensation hood,
after the cooking chamber door has been
opened
30 °C (86 °F) — Preset temperature for steaming
130 °C (266 °F)
30 °C (86 °F) — Preset temperature for combisteaming
250 °C (482 °F)
30 °C (86 °F) — Preset temperature for hot air
300 °C (572 °F)
30 °C (86 °F) — Preset temperature for regeneration
180 °C (356 °F)
0 — 300 min Maximum waiting time after reaching the
Ready2Cook temperature, for set value <
250 °C (482 °F)
0 — 60 min Maximum waiting time after reaching the
Ready2Cook temperature, for set value >
250 °C (482 °F)
0 = 24 h Set the 12-h or 24-h time format
1 = 12 h