Henny Penny FlexFusion Installation Manual page 38

Putting the unit into service
Unit of temperature set?
°C
Have date and time been set?
Has software version been identified?
Version: __________
Altitude set?
0 — 999 m (3277 ft)
2000 m (6560 ft) — 2499 m (8197 ft)
80 % power set?
100 %
Current voltage set?
Voltage: ________ V
Audible signal volume set?
quiet
Has signal tone been selected?
Volume unit set?
ml
fl.oz. (U.S.)
Power optimisation system set?
On
Water filter maintenance set?
No maintenance message
Has network configuration been set?
DHCP
Subnet mask: ____________________________
Has kitchen management system been set?
Active
Ethernet
TCP port: __________
Unit address: __________
Connection pressure within indicated range?
Connection pressure:
Water connection made properly?
Lines and connections leak-tight?
Water connections connected with T-piece?
Connected only to softened tap water
38
Basic control setting
°F
1000 m (3280 ft) — 1999 m (6557 ft)
2500 m (8200 ft) or higher
80 %
loud
fl.oz. (Imperial)
Off
Maintenance message at: _______________ l
(gal)
IP address: ____________________________
Gateway: ____________________________
Disabled
Serial
Unit address: __________
Water connection
(
Connected only to tap water
Installation instructions
Yes No
Yes No
) kPa (psi)