Control Elements And Connections; Front And Rear View - TESTO CU-2 User Manual

4.5.

Control Elements and Connections

4.5.1.

Front and Rear View

Fig. 4.3: front view of testo CU-2
Fig. 4.3 shows the front of testo CU-2. There are no control elements except the power LED 1)
indicating if the device is switched ON or OFF. All connectors and the mains switch are located at
the rear side which is shown in Fig. 4.4. The testo CU-2 is either completely controlled via
Ethernet or locally by using keyboard, mouse and VGA monitor which can be connected to the
according ports.
Fig. 4.4: rear view of testo CU-2
1 Power LED
2 testo ASET15-1 Air Supply / Evaporation Tube (PND2 + VPR) interface
3 testo MD19-3E Rotating Disk Diluter (PND1) interface
4 male 25 pin D-Sub connector for analog and digital in- and output signals
5 USB connector of embedded computer
6 USB connector of embedded computer
7 USB connector of embedded computer
PMP R-83 measurements
8 USB connector of embedded computer
9 not used
10 LAN 2 connector of embedded computer; default setting: DHCP
11 LAN 1 connector of embedded computer; default IP adress: 192.168.1.129
12 VGA monitor connector of embedded computer
13 Male serial connector 1 of embedded computer
PMP R-83 measurements
14 Male serial 2 connector of embedded computer
15 not used
16 Female serial 3 connector to control testo CU-2 by AK host computer
17 Mains connector
18 Fuse holder; fuse: 250 V, 5.0 A, t
19 Mains switch
8
used as default port for GRIMM 5.431 for
used as default port for EECPC 3790 for
4 System Overview
11