Analog In; Analog Out - TESTO CU-2 User Manual

Fig. 6.7: analog input and output signals configuration tab
6.4.1.

Analog In

Using the round check buttons, every analog input and output channel can be activated or
deactivated individually. Active input signals will be recorded in the measurement file during data
logging and will be available for being displayed on the 'Measurement' tab.
For every channel an analog DC voltage range within – 10 V DC...+10 V DC can be specified to
equate a certain signal range. Furthermore, the signal can be named and serial number and
signal unit can be entered which will also be saved during data logging.
6.4.2.

Analog Out

Fig. 6.8: analog and digital output signal menues
The 4 analog output signals can also be enabled individually. For every voltage output, one
signal can be selected from the menu which is opened by clicking on the signal selection bar.
The output voltage range is 0...+10 V DC. The signal range corresponding to this voltage limits is
set by the operator.
6 testo NanoMet Operation
23