Designation Of All Testo Cu-2 Digital Control Unit Operating Elements - TESTO CU-2 User Manual

10 Appendix
10.3.

Designation of All testo CU-2 Digital Control Unit Operating Elements

1 Power LED
2 testo ASET15-1 Air Supply / Evaporation Tube (PND2 + VPR) interface
3 testo MD19-3E Rotating Disk Diluter (PND1) interface
4 male 25 pin D-Sub connector for analog and digital in- and output signals
5 USB connector of embedded computer
6 USB connector of embedded computer
7 USB connector of embedded computer
PMP R-83 measurements
8 USB connector of embedded computer
9 not used
10 LAN 2 connector of embedded computer; default setting: DHCP
11 LAN 1 connector of embedded computer; default IP adress: 192.168.1.129
12 VGA monitor connector of embedded computer
13 Male serial connector 1 of embedded computer
PMP R-83 measurements
14 Male serial 2 connector of embedded computer
15 not used
16 Female serial 3 connector to control testo CU-2 by AK host computer
17 Mains connector
18 Fuse holder; fuse: 250 V, 5.0 A, t
19 Mains switch
Fig. 4.3 : front view of testo CU-2
Fig. 4.4: rear view of testo CU-2
Fig. 4.5: external signals connector
40
used as default port for GRIMM 5.431 for
used as default port for EECPC 3790 for
8