Changing Bulbs In The Rear Lights - Hobby ONTOUR 2018 Operating Manual

12. Maintenance and upkeep

12.4 Changing bulbs in the rear lights

1
Registration plate light
2
Removing the cable
4
Lamp
Different rear lights are used in the Premium models. Unfortunately,
it is not possible to replace these lights easily. In this case, please
speak to your dealer, who will be pleased to assist you in changing
these light bulbs
Some of the rear lights in the Premium models are
fitted with LED lights, whereby each individual light
has a standardised alignment. Therefore, due to the
authorisation required, individual LED lights may not
be changed. Should they be defect, the entire rear light
must be replaced.
Disconnect the power supply before changing the
lamps!
Lamps can be hot!
Ensure that no liquids (e.g. rain) flow into the covers.
Changing the licence plate illumination
• To change the registration plate light, first unscrew these
.
screws j
• Remove the two wires
(They can re connected to any terminal).
• When putting in the new light, take care to ensure that the clo-
sed side
l
k
bumper . Otherwise there is a danger that the plastic on
the rear bumper will melt when heat is generated.
3
• Firmly tighten the screws
.
k
and attach them to the new light
of the light points towards the plastic on the rear
j to fasten the light securely.
150