How To Convert Seating Areas Into Beds - Hobby ONTOUR 2018 Operating Manual

Securing the table
4
1
Hanging table
Supporting legs
3
Lowered hanging table

6.4 How to convert seating areas into beds

1
1
2 3
Converting the seating area to a bed
49
Hanging table
To lower
• Raise the front end of the table top by approx. 30°.
• Pull down the lower part of the table leg
and lay it on its end.
• Fold out the supporting legs
• Pull the table top out of the upper wall brackets
• Raise the front end of the table top considerably and hook it
diagonally from above into the lower wall brackets
• Place the supporting legs at the front edge of the table top on
the floor.
2
Converting the seating area
The seat groups can be converted into comfortable beds.
1
Preparing to convert the bed
2
• Lower the table (see Chapter 6.3 Tables).
3
• If necessary, fold out the bed expansion in the seating area
(model-specific).
Notes on arranging the cushions:
- How to arrange the cushions depends on the caravan model.
- In some caravan models, one or more additional cushions are
required to convert the bed. These are included separately in
the caravan.
- In main seating area, the rear seat cushions
- Depending on the model, it may be necessary to remove the
side back
cushions
k
seen/felt should be filled with one or more additional cushions.
.
Neither the metal elevating table leg nor the single-post
elevating table leg are fastened to the floor. Before
driving, lower the table and, depending on the model,
secure it with one or two pushbuttons either to the seat
base or to the front/rear wall.
k
and seat cushions
l
towards the middle and place the back cushions
horizontally along the sides. Any open space that can still be
6. Interior structure
j
, fold it over by 90°
k
by 90°.
l
.
j
remain in place.
l
. To do this, push the seat
m
.