Hobby ONTOUR 2018 Operating Manual page 93

1
Circuit board (reverse side)
of TFT display
1
2
3
Remote control for the control panel
89
7. Installation of electrical devices
General information regarding the TFT display
The time and date are powered by a 3V 210 mAh, CR2032 type bat-
tery. If, therefore, the time should be incorrect or the clock should
stop working, this battery must be replaced. It is mounted on the
reverse of the circuit board of the TFT display. To replace this bat-
tery, the TFT display must be removed from the furniture front by
carefully clipping the chrome-plated frame out of its holder. You
will then see the screws that fasten the plastic part to the furniture.
Loosen these screws to detach the display.
Remote control*
• The hand-held transmitter is used to switch six functions on the
control panel via remote control.
4
1
5
2
3
6
4
5
6
When replacing the battery, please ensure that plus
and minus are in the right direction. Incorrect polarity
may cause the display to become defective.
left bed
wall light
main switch
right bed
ceiling light
awning light