Brakes; Changing Bulbs In The Rear Lights - Hobby OPTIMA ONTOUR EDITION 2019 Manual

12.2 Brakes

The components in the brake system are part of the General
Type Approval ("Allgemeinen Betriebserlaubnis", ABE).
If you change the components in the brake system, the type
approval expires. Any changes are only possible if they have
been released by the manufacturer.
It is in your own interest to have the brakes checked
regularly by your Fiat or Citroën- workshop.
The following applies when maintaining the brake system
• Check the level of brake fluid regularly.
• Check the brake system and brake hoses regularly for lea-
kage. Rodents often gnaw at rubber hoses.
• Use only brake fluids with the same qualities as those
fluids already in the brake circuit.
For further information, please refer to the Fiat Ducato or
Citroën Jumper operating instructions.
12.3 Changing the rear lights
If several lamps have to be replaced, take care to ensure
that they are not accidentally switched and that everything
is put back in its original place.
Before changing lamps, disconnect the power supply in the
vehicle and switch the ignition off.
Lamps can be hot!
Ensure that no liquids (e.g. rain) flow into the covers.
Siesta
1
Optima rear light
2
Removing the cable
12. Maintenance and Care
• Unscrew the two screws
in the defect lamp.
• Remove the defect lamp from
the lighting support and pull
out the cable by pressing the
k
two clamps together.
213
j