Hobby ONTOUR 2018 Operating Manual page 66

7. Installation of electrical devices
Wall light/lighting
in the seating area
Functions of the main switch
• After initially connecting the caravan to the 230 V mains, you must
press either the main switch or any other control key in order to
activate all of the 12 V electrical devices and the 230 V electrical
devices that are switched by the system (e.g. Truma Therme water
heater, floor heating
• Once the system is in operation, press the main switch briefly to
turn all of the lights off. All of the 12 V steady electrical devices (e.g.
water supply, refrigerator control, heat blower) remain activated.
The devices that were previously switched on are stored in the
system; pressing on the main switch reactivates them. This also
resets the degree to which those lights were dimmed that can be
adjusted.
• Pressing the main switch for at least four seconds while the sys-
tem is switched on will turn off not only the presently activated
devices, but also the entire 12 V system (also affects flushing the
toilet and water pump; in self-sufficient caravans, this will not cut
off the charging of the battery)
• If there should be a power failure, the system will remember
whether the main switch was on or off. As soon as the power
is back on, the main switch will automatically switch itself back
on. Electrical devices that continuously use current, such as the
heating, will then begin to operate again.
Wall lights / lighting in the seating area and Ceiling Lamp
• Briefly press the buttonto switch each lamp on and off. Press
longer on the button to adjust how brightly you want the lights to
shine. The brightness you set will be saved; when the lights are
switched on again, the brightness you originally set will also be
Ceiling light
switched on again. If the system's power supply is interrupted, the
wall light will shine full strength the first time you switch it on.
If the intensity has been reduced to a minimum by dimming the
lights, the lamp will switch itself off. Since this setting is saved,
the dimmer must be reset to the brightest level before the light will
shine again. For technical reasons, if the light is set to the very lo-
west dimmed level, the light may flicker. If this bothers you, please
increase the brightness of the light..
*
).
If the selector switch of the Dometic refrigerator has
been set to 12 V, the refrigerator will operate automati-
cally on 12 V when the ignition of the base vehicle has
been switched on, i.e. it is not necessary to press the
main switch.
All other 12 V electrical devices will only operate on the
battery of the tow vehicle if they have been centrally
activitated using the main switch on the control panel.
In caravans with two ceiling lights, one light can only
be switched on separately.
62