Hobby ONTOUR 2018 Operating Manual page 156

12. Maintenance and upkeep
6 5 4
Multifunctional light in Prestige model
Fig. 1
Fig. 2
Reverse side of rear light
Marking on the lamp
Changing the rear lamps in the Prestige model
1
Rear light (LED)
j
2 3 k
Fog tail light (light bulb)
l LED
m Reversing light (light bulb)
n Indicator (light bulb)
o Brake light (light bulb)
Releasing the rear lamp from the sealing
• Release the rear lamp by carefully applying a plastic wedge beneath
the outer edge of the lamp (Fig. 1).
• Before lifting the lamp out of the sealing, use one hand to hold the
inner edge of the lamp in place (Fig. 2). When releasing the lamp,
ensure that it does not shift or is wedged towards the centre of the
vehicle.
• Release the lamp slowly and evenly from the sealing
• The sockets of the light bulbs are marked; unscrew them as de-
scribed. Replace the defect bulb and then screw the socket back
into the rear lamp retainer.
Inserting the rear lamp in the sealing
• Place the rear lamp back in the sealing by carefully pushing the
rear light into the inner corner and pressing it lightly into place.
• Then press the outer edge into the sealing, whereby the inner
corner of the lamp must not be shifted.
• Check that the lamp is fully locked into place and fits smoothly.
The LED components in the rear light cannot be chan-
ged separately. In case of defects, the entire rear lamp
must be exchanged.
Never mix up the predefined positions of the lamps on
the rear lamp and always ensure that they are screwed
tightly into place.
152