Verification Stamp Option - Sharp FO-DC500 Network Manual

Verification Stamp Option

3
START/
Press
ENTER
until the desired setting is selected.
•
Note: "TX" stands for "transmission"
and "RX" stands for "reception".
"AUTO" and "MANU" indicate AUTO
and MANUAL reception modes.
4
START/
Press
ENTER
5
Go back to Step 3 to select a setting for the other line, or press
exit.
Verification Stamp Option
When transmitting a document, you can have the machine stamp each
document page as it is scanned. After scanning, you can check to see if all
documents have been stamped to verify that no double feeds occurred. (A
double feed occurs when two pages are fed through the scanner at once,
which means that one of the pages is not scanned.)
To use this function, have your dealer install the Verification Stamp option,
and then set Option Setting 29 to ON as explained on page page 197.
70
and then or
.
Settings for Line 1:
LINE 1 SETTING
1=TX AND RX (AUTO)
2=TX AND RX (MANU)
3=RX (AUTO) ONLY
4=RX (MANU) ONLY
Settings for Line 2:
LINE 2 SETTING
1=TX AND RX (AUTO)
2=TX ONLY
3=RX ONLY
STOP
to