Sharp FO-DC500 Network Manual page 197

Setting 20: ANTI-JUNK FAX
Select ON to block reception from fax numbers entered in the Anti Junk Fax
List. Select OFF to allow reception from all numbers. Press
make the selection and then press
♦
Initial setting: OFF
Setting 21: ALARM VOLUME
This sets the volume of the beep sound that alerts you to error conditions and
informs you that operations have been completed. Press
select a volume level (HIGH, LOW or OFF) and then press
♦
Initial setting: LOW
Setting 22: DIAL MODE
This sets the dial mode. Select TONE if you are on a touch-tone line, or
PULSE if you are on a pulse dial (rotary) line. Press
the selection and then press
♦
Initial setting: TONE
Setting 23: QUICK ON-LINE
When you transmit a multi-page document, this setting determines whether
the machine will dial the receiving party and begin transmitting while scanning
is still in progress, or wait until all pages have been scanned before dialing.
Select ON to have the machine dial and begin transmission while scanning is
still in progress, or OFF to have the machine wait until all pages have been
scanned. Press
♦
Initial setting: ON
Setting 24: MULTI TTI
If you are using Department Control, you can select ON to have the
department name (the name associated with the department code entered by
an operator to access the fax) appear at the top of each transmitted
document. This will appear in place of the name entered in Entering Your
Name and Fax Number in Chapter 1. Select OFF to turn Multi TTI off (the
START/
.
ENTER
START/
.
ENTER
or to make the selection and then press
Optional Settings
or to
or to
START/
..
ENTER
or to make
START/
.
ENTER
195