Sharp FO-DC500 Network Manual page 198

Optional Settings
sender's name entered in Chapter 1 will appear). Press
make the selection and then press
♦
Initial setting: OFF
Setting 25: BEEP LENGTH
This sets the duration of the beep that signals the end of transmission,
reception, and copying. Press
SECONDS, 1 SECOND, or NO BEEP) and then press
♦
Initial setting: 3 SECONDS
Setting 26: TELEPHONE BILLING CODE
This setting allows you to use Department Codes or direct billing codes for
telephone billing on a PBX. (Your dealer must first activate Department
Control or direct billing code entry.) Select ON to turn telephone billing on, or
OFF to turn it off. Press
START/
.
ENTER
♦
Initial setting: OFF
If you selected ON, the BILLING CODE DIAL selection will subsequently
appear. Select BEFORE if your PBX must receive the billing code before
dialing a telephone number, or AFTER if it must receive the billing code after
dialling a telephone number, and then press
manual or consult your PBX adminstrator for this information.)
Note: If you select AFTER for the BILLING CODE DIAL selection, you must press
REDIAL
after dialing if you use
Setting 27: DEPARTMENT CODE DIGITS
Use this setting if you are using Telephone Billing and need to change the
number of digits of Department Codes to accord with your PBX's telephone
billing system. Enter any number from
♦
Initial setting: 4
196
START/
.
ENTER
or to select a duration (3
or to make the selection and then press
START/
ENTER
SPEAKER
.
to
3
9
or
START/
.
ENTER
. (Refer to your PBX
.
to