Alarm List - Sanken SAMCO-NS Series Instruction Manual

Alarm list

7-segment
Alarm
Check points
monitor
description
display
AL1
Memory Turn off the power, while CHARGE
Abnormality Lamp turn off, turn the power on again,
And check the alarm.
AL2 System Excessive external noise?
AL3 Are the signal and power lines
Abnormality
separated far enough?
AL4 System Abrupt capacitor discharge? turn
off the power, so, the CHARGE
Abnormality
lfamp turn off, turn the power
on again and check the alarm.
AL5
System Excessive external noise?
AL9
Abnormality Are the signal and power lines
separated far enough?
Actions
Contact the supplier
Install a noise collector or filter
Keep the signal line far away from the
power line
Reconfirm the modified code data. Turn the
power on/off several times, if the alarm is still
on, pls. reset the system, using F1604=1, and
then turn power on and off again, All the
function data is initialized to the factory preset.
Install the noise collector and filter.
Keep the signal line far away from the
power line
-69-