Confirmation - Sanken SAMCO-NS Series Instruction Manual

∧
【 】*4
【＞】
∧
【 】*13
【ENTER】
∧
【 】*9
【ENTER】
1 When no needing to set the new value, return to parameter number setting interface through
※
【PROG】Key.Parameter numble in the second monitor flashing.

Confirmation

Some function codes need to re-confirm for the prevent of wrong operation which could be caused
of data re-written.
For example：set F1001=10
Operation Display
【PR/CL】
Press【∧】key, changing number to 14, second display
parameters number 14 flashing, may be revised again.
Press【＞】key switch to parameters number revised
mode, second display parameters number 01 flashing,
the value could be revised
Press【∧】Key, parameters number revise to 14,
Seondary monitor parameters number 14 flashing,
may be revised.
Press【ENTER】Key, switch to parameters modify mode,
primary monitior F1414 value 1 flashing,
may be amended.
Press【∧】key, revised the parameters value to
10, primary monitor F1414 revised value 10 flashing,
and can be amended.
Press【ENTER】key, confirm the changing value,
secondary monitor parameter number 14 flashing,
may be modified. Parameter value revised finished.
.
Description
Status monitor display（Frequency display）
Press【PR/CL】key show display function code input
interface, secondary monitor paramerter no: 10 flashing,
may be ameneded.
-23-