Basic Operation; Function Code Setting - Sanken SAMCO-NS Series Instruction Manual

During status monitor display, frequency setting as the below method whatever is on operation or at stop
For Example：From 5Hz to 45Hz
Operation Display
【ENTER】
【＜】*3
∧
【 】*4
【ENTER】
1
※ While no needing the frequency setting，press【PR/CL】key return to status monitor display Mode.

Basic operation

Function code setting

Normal operation used for the changing the value of function code.
For example: set F1414=10
Operation Display
【PR/CL】
Description
Status monitor display（Frequency display）
Input value display the last right digit.
(Revise the value while this digit flashing)
( 1)
※
Press 【＜】key one time, flahsing position will move to
the left on one digit.
Press【＜】key 3 times，ten digits flashing.
（※1）
Press【∧】key every one time, value added 1
Press【∨】key every one time, value minus 1
Press【∧】key 4 times, ten digits value will be changed
to "4"
Press【ENTER】, frequency setting finished, and then back
to the status monitor interface.
Description
Status monitor display（frequency display）
Press【PR/CL】key show function code input
interface.
Second display parameters number10 flashing,
and the value could be revised.
-22-