Table of Contents
Advertisement
2.
Set Baud Rate on Bottom Dip Switch to the same as Baud Rate setting on the keyboard you are using.
3.
Set specific camera address that you want to control the camera for on Bottom Dip Switch.
4.
If you want to have the camera address to be automatically assigned by VISCA controller, set camera Dip Switch address to
0.
5.
Reboot the camera by turning it Off/On after the Bottom Dip Switch has been set up correctly.
Use the RS422 control cable provided by third party controller. The controller must be VISCA compatible.
6.
7. Camera supports Daisy Chain connection up to 7 cameras.
8. The connection of SONY keyboard is different than other VISCA (None-Sony) keyboard.
9.
How to make RS422 connection and RS422 Daisy Chain multiple cameras connection with SONY controller as below
SONY Keyboard RS422 Connection
10.
How to make RS422 connection and RS422 Daisy Chain multiple cameras connection with Non-Sony controller as below
VISCA (None-Sony) Keyboard RS422 Connection
11. Use multicore control cable to make the RS422 connection for your control device that has standard RS422 serial
control port.
12.
How to make RS422 Daisy Chain multiple camera connection with RS422 standard serial port controller:
14
:
Advertisement
Table of Contents
