Table of Contents
Advertisement
1.
Set RS232 control method on Bottom Dip Switch.
2.
Set Baud Rate on Bottom Dip Switch to the same as Baud Rate setting on the keyboard you are using.
3.
Set specific camera address that you want to control the camera for on Bottom Dip Switch.
4.
If you want to have the camera address to be automatically assigned by VISCA controller, set camera Dip Switch address to
0.
5.
Reboot the camera by turning it Off/On after the Bottom Dip Switch has been set up correctly.
Use the RS232 control connection cable provided by third party controller (VISCA). The controller must be
6.
VISCA compatible.
7. Camera does not support Daisy Chain in RS232 control mode.
8. Use the 8-pin mini din RS232 cable that is provided by controller to connect the camera to the controller.
You can make RS232 connection cable if you have the following applications:
9.
10. Use RS232 8 pin Mini Din cable to make RS232 connection for your control device that has 8 Pin Mini Din
RS232 serial control port.
12
Advertisement
Table of Contents
