Table of Contents
Advertisement
Service Manual
Minor repair
Speed sensor
66
Series 90 Pumps
Filter screen installation
B90
P106 690E
Removal
1. Loosen the lock nut using a 11/16 in hex wrench.
2. Unscrew the speed sensor (B83) from the pump housing. Remove and discard the O-ring (B83A).
Reassembly
1. Install a new O-ring before reinstalling the sensor.
2. Reinstall the speed sensor (with lock nut and O-ring) into the housing. Adjust the gap between the
sensor and the magnetic speed ring as instructed in Speed sensor adjustment (page 46) and torque
the sensor lock nut to 13 N•m [10 lbf•ft].
3. If a speed sensor is not installed, use a 1/4 in internal hex wrench to torque the housing plug (B83) to
40 N•m [30 lbf•ft].
520L0818 • Rev 0101 • August 2015
Advertisement
Table of Contents
