Pump Control Cover Plate - Danfoss 90 Series Service Manual

Service Manual
Minor repair
Integral charge pressure filter

Pump control cover plate

56
Series 90 Pumps
N25
N40
Removal
1. Thoroughly clean external surfaces prior to removal of cover plate.
2. Using a 5 mm internal hex wrench, remove the six cover plate mounting screws (M90). Remove the
cover plate (M1) and gasket (M11) from housing. Discard the gasket.
C
Caution
Protect exposed surfaces and cavities from damage and foreign material.
Reassembly
Install a new gasket on the housing. Install the cover plate and install the screws. Torque the screws to
16 N•m [12 lbf•ft].
Install a sealing washer under the head of any mounting screws that are installed into through holes in
the housing.
520L0818 • Rev 0101 • August 2015
N20
Filter manifold lock nut
N15
Lock nut torque
N36A
N36
N10
N35A
N35
11/16 in
37 N•m [27 lbf•ft]
11/16 in
37 N•m [27 lbf•ft]
P106 182E