Install The Fips Opacity Shield - Cisco Firepower 4100 Series Hardware Installation Manual

Install the FIPS Opacity Shield

Step 7
Prepare the other end of the grounding cable and connect it to an appropriate grounding point in your site to ensure
adequate earth ground.
What to do next
Install the FIPS opacity shield if necessary. See
Continue with
Install the FIPS Opacity Shield
Caution This procedure should be performed only by the Crypto Officer.
Note Because the FIPS opacity shield covers the serial number on the chassis, you need to copy the serial number
on a label and attach it to the chassis where it can be retrieved or viewed easily before you install the FIPS
opacity shield. You need the serial number when you call Cisco TAC.
Before you begin
You need the following to install the FIPS opacity shield:
• #1 Phillips head screwdriver
• The following items from the FIPS kit:
• The following items from the Firepower 4100 series accessory kit:
Step 1
Copy the serial number on a label and attach it to the chassis where it can be retrieved easily for future use if needed.
To find the serial number, see
Step 2 Pull the chassis out of the rack until the release latches catch.
Step 3
If you have not already done so, attach a slide rail locking bracket to each side of the chassis using the six 8-32 x .375-in.
countersink Phillips head screws provided in the accessory kit.
Cisco Firepower 4110, 4120, 4140, and 4150 Hardware Installation Guide
48
Connect Cables, Turn on Power, and Verify Connectivity, on page
• One FIPS opacity shield
• Four 8-32 x .375-in. countersink screws used to attach the FIPS opacity shield to the cable
management brackets
• 15 tamper-evident labels (TELs)
• Two cable management brackets
• Four 8-32 x .375-in. countersink screws used to attach the cable management brackets to the slide
rail locking brackets
Serial Number Location, on page
Install the FIPS Opacity Shield, on page 48
5.
Mount and Connect
for the procedure.
53.