Discarding Oil From Vat Using Oil Discard Shuttle - Henny Penny LVE-202 Operation Manual

3-15. DISCARDING OIL
FROM VAT USING
OIL DISCARD
SHUTTLE
Figure 1
Figure 2
Aug. 2010
NOTE: ENSURE DISPOSE IS SET TO NO OR VAC
1. Open center door and pull the drain pan assembly from under fryer
and replace with oil discard shuttle. Figures 1 & 2.
2. Press and hold (on either side) until display shows "*FILTER
MENU*", along with "1.AUTO FILTER?".
3. Press and release button twice until display shows
ü
"3.DISPOSE". Press
"YES NO". (If control suspects oil in drain pan "CAUTION IS
THERE OIL IN PAN? YES NO" may show in display. Make sure
drain pan is empty before proceeding )
ü
4. Press button and display shows "IS DISPOSAL UNIT IN
PLACE? "YES NO".
5. With discard shuttle rolled into place, press
shows "DRAINING". Oil now drains from the vat into the shuttle.
6. Display shows "VAT EMTY "YES NO". Verify that vat is empty,
ü
and press button.
7. Display shows "CLEAR OLD OIL FROM OIL LINES"
ü
" =PUMP" "X =DONE". To make sure no old oil remains in
the oil lines, press and hold
lines are clear, press X button.
8. Display shows "CLN VAT COMPLETE" "YES NO". Once vat is
ü
clean, press button.
9. Display shows "MANUAL FILL POT", followed by "IS POT
FILLED" "YES NO". Fill the vat to the lower indicator line on the
rear of the vat and then press
Oil (locations without RTI) instructions from Section 3-2.
Controls return to normal operation.
10. Remove the discard shuttle from under fryer and replace with the
filter pan assembly.
3-17
Model LVE-202, 203, 204
button and display shows "DISPOSE?"
ü
button and display
ü
button for a few seconds. Once
ü
button. (See Filling or Adding