Henny Penny LVE-202 Operation Manual page 33

3-16. DISCARDING OIL
USING NON-RTI (REAR)
SYSTEMS
June 2012
WITH PROLONGED USE, THE FLASHPOINT OF
SHORTENING IS REDUCED. DISCARD SHORTENING
IF IT SHOWS SIGNS OF EXCESSIVE SMOKING OR
FOAMING. SERIOUS BURNS, PERSONAL INJURY, FIRE,
AND/OR PROPERTY DAMAGE COULD RESULT.
NOTE: ENSURE DISPOSE IS SET TO REAR
1. Remove pipe plug from the DISPOSE OIL OUT elbow in the rear
of the fryer, and attached dispose plumbing to the elbow; 1/2 inch
diameter, standard NPT threads.
2. Be sure the BULK OIL DISPOSE is set to REAR in the SETUP
Mode. See Section 4-4.
3. Press and hold (on either side) until display shows "*FILTER
MENU*", along with "1.AUTO FILTER?".
4. Press and release twice until display shows 3.DISPOSE.
ü
5. Press button and display shows "DRAIN VAT" "YES NO".
ü
6. Press button and display shows "DRAINING" and oil drains
into the filter drain pan. (If control suspects oil in drain pan
"CAUTION IS THERE OIL IN PAN? YES NO" may show in
display. Make sure drain pan is empty before proceeding )
7. Display then shows "VAT EMTY" "YES NO".
ü
8. Press button and display shows "CLEAR OLD OIL FROM
ü
OIL LINES" " =PUMP" "X =DONE".
old oil remains in the oil lines, press and hold
seconds. Once lines are clear, press X button and display shows
"CLN VAT COMPLETE" "YES NO". Once clean, press
ü
9. Press button. Display shoes "DISPOSING..." "X=STOP.
10. When all oil is pumped from pan, press X button (STOP).
12. Press X button and display shows "MANUAL FILL VAT",
followed by "IS POT FILLED?", along with "YES NO". Fill the
vat to the lower indicator line on the rear of the vat. See Filling or
Adding Oil instructions from Section 3-3
3-18
Model LVE-202, 203, 204
To make sure no
ü
button for a few
ü
.