Henny Penny LVE-202 Operation Manual page 54

6-1. TROUBLE SHOOTING
GUIDE (Continued)
Problem
Oil foaming or boiling
over top of vat
Oil will not
drain from vat
Filter motor runs but
pumps oil slowly
Bubbles in oil during
entire filtering process
Control error code "E-31"
Filter motor will not run
Aug. 2010
Cause
• Water in oil
• Improper or bad oil
• Improper filtering
• Improper rinsing after
cleaning the vat
• Drain valve clogged with
crumbs
• Drain trough clogged
• Filter line connections loose
• Filter paper or pad clogged
• Filter pan not completely
engaged
• Filter pan clogged
• Damaged O-ring on filter line
receiver on fryer
• Elements are up
• Power cord for vat #1 is not
plugged-in
• Open circuit
• The thermal reset button on
the rear of the pump motor is
tripped
6-2
Model LVE-202, 203, 204
Correction
• Drain and clean oil
• Use recommended oil
• Refer to filtering procedures
• Clean and rinse vat and then dry
thoroughly
• Open valve, use straight white brush to
force crumbs through drain valve
Do not leave brush in drain valve.
• Remove right side panel and remove plug
from end of trough and clean trough
• Tighten all filter line connections
• Change filter paper or pad
• Make sure filter pan return line is pushed
completely into the receiver on the fryer
• Clean pan and change paper or pad
• Change O-ring
• Lower elements back into vat
• Plug power cord into receptacle
• Breakers in fryer tripped-open left door
and reset breaker on fryer
• Allow time for the motor to cool; remove
the JIB and then, using a screwdriver,
press hard against the button until it clicks