Installing The Pix 515/515E - Cisco PIX Series User And Installation Manual

Chapter 4 PIX 515/515E
Figure 4-4
Figure 4-4
Table 4-2
Table 4-2
LED
100 Mbps
ACT
LINK
The inside or outside network connections can be made to any available interface port on the
PIX 515/515E. If you are only using the ETHERNET 0 and ETHERNET 1 ports, connect the inside
network cable to the interface connector marked ETHERNET 0 or ETHERNET 1. Connect the outside
network cable to the remaining Ethernet port.
The USB port to the left of the Console port is not used. The detachable plate above the ETHERNET 1
connector is also not used.

Installing the PIX 515/515E

This section contains the following topics:
•
•
•
•
78-15170-03
shows the rear panel LEDs.
PIX 515/515E Rear Panel
100 Mbps 100 Mbps
LED LED
LINK
ACT
LED
LED
100 Mbps ACT
LINK 100 Mbps
10/10 0 ETHE RNET 1
10/100BaseTX
ETHERNET 1
(RJ-45)
lists the states of the rear panel LEDs.
PIX 515/515E Rear Panel LEDs
Color Status
Green On
Green Flashing Shows that data is passing on the network to which the connector is
Green On
Off
Surface Mounting the PIX 515/515E, page 4-4
Removing and Replacing the PIX 515/515E Chassis Cover, page 4-13
Vertical Mounting the PIX 515/515E, page 4-5
Installing a Circuit Board in the PIX 515/515E, page 4-19
USB
ACT
LINK
LED
LED
FAILOV ER
ACT
LINK
10/10 0 ETHE RNET 0
USB
CON SOLE
10/100BaseTX Console
ETHERNET 0 port (RJ-45)
(RJ-45)
Description
100 megabits per second 100BaseTX communication. If the light is
off, that port is using 10 megabits per second data exchange.
attached.
Shows that the connection uses full duplex data exchange where
data is transmitted and received simultaneously.
If this light is off, half duplex is in effect.
Cisco PIX Security Appliance Hardware Installation Guide
Installing the PIX 515/515E
Power switch
4-3