Removing And Replacing The Pix 520 Chassis Cover; Removing The Chassis Cover - Cisco PIX Series User And Installation Manual

Removing and Replacing the PIX 520 Chassis Cover

Removing and Replacing the PIX 520 Chassis Cover
This section describes how to remove and replace the chassis cover from the PIX 520. This section
includes the following topics:
•
•

Removing the Chassis Cover

To remove the chassis cover, perform the following steps:
Removing the PIX security appliance case does not affect your Cisco warranty. Upgrading the
Note
PIX security appliance does not require any special tools and does not create any radio frequency leaks.
Read the
Step 1
Ensure that the PIX security appliance is powered off. Unplug the power cord from the power outlet.
Step 2
Once the upgrade is complete, you can safely reconnect the power cord.
Warning Before working on a system that has an On/Off switch, turn OFF the power and unplug the power cord.
Remove the three screws holding the chassis cover in place, as shown in
Step 3
Figure 5-11 Removing the Chassis Cover Screws
Cisco PIX Security Appliance Hardware Installation Guide
5-10
Removing the Chassis Cover, page 5-10
Replacing the Chassis Cover, page 5-11
Regulatory Compliance and Safety Information
Top panel screws (3)
PIX Fir ew all
RESET
SERI ES
document.
Figure 5-11.
Chapter 5 PIX 520
78-15170-03