Cisco PIX Series User And Installation Manual page 39

Chapter 3 PIX 506/506E
Figure 3-6
power cord connector (at the opposite end of the power supply).
Figure 3-6
Figure 3-7
power cord connector (at the opposite end of the power supply).
Figure 3-7
To connect the power supply module, perform the following steps:
Place the PIX 506/506E on a flat, stable surface. The PIX 506/506E is not rack mountable.
Step 1
Connect the power supply to the back of the PIX 506/506E. See
Step 2
Figure 3-7
When you are ready to start the PIX 506/506E, power on the unit from the switch at the rear of the unit.
Step 3
78-15170-03
displays the cable connection from the power supply to the PIX 506, and displays the AC
Connecting the Power Supply Module to the PIX 506 6-Pin Connector
ACT
LINK
ETHE RNET 1
Power supply
displays the cable connection from the power supply to the PIX 506E, and displays the AC
Connecting the Power Supply Module to the PIX 506E 8-Pin Connector
ACT
LINK
ETHE RNET 1
Power supply
for the PIX 506E.
Connecting a Power Supply Module to the PIX 506/506E
ACT
LINK
ETHE RNET 0
USB
CON SOLE
ACT
LINK
ETHE RNET 0
USB
CON SOLE
Figure 3-6
Cisco PIX Security Appliance Hardware Installation Guide
DC
POWE R
INPUT
DC
POWE R
INPUT
for the PIX 506 and
3-5