Cisco PIX Series User And Installation Manual page 66

Installing the PIX 515/515E DC Model
Insert the ground wire into the connector for the earth ground and tighten the screw on the connector.
Step 6
Refer to
then the positive wire.
Note
After wiring the DC power supply, remove the tape from the circuit breaker switch handle and reinstate
Step 7
power by moving the handle of the circuit breaker to the ON position.
Install any remaining interface boards as described in the
Step 8
PIX 515/515E" section on page
Power on the unit from the switch at the rear of the unit.
Step 9
If you need to power cycle the DC PIX 515/515E, wait at least five seconds between powering off the
Note
unit and powering it back on.
Cisco PIX Security Appliance Hardware Installation Guide
4-24
Figure 4-24 and, using the same method as for the ground wire, connect the negative wire and
The DC return connection to this system is to remain isolated from the system frame and
chassis (DC-I).
4-19.
Chapter 4
"Installing a Circuit Board in the
PIX 515/515E
78-15170-03